Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Toyota vehicle intrusion protection system / Tvip ecu communication circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Check tvip ecu
- Check that the operation of the tvip function is normal.
Hint
: with this inspection, the tvip ecu cpu can be diagnosed if it works normally or not.
2 Check wire harness (tvip ecu integration relay)
- Disconnect the tvip ecu and integration relay connectors.
- check the continuity between the terminal of the tvip ecu connector and integration relay connectors, as shown in the illustration and table.
Standard:
Check and replace tvip ecu
Other materials:
Engine rear oil seal
Replacement
1. Remove manual transaxle assy (m/t transaxle)
2. Remove automatic transaxle assy (a/t transaxle)
3. Remove clutch cover assy (m/t transaxle)
remove the 6 bolts and clutch cover.
4. Remove clutch disc assy (m/t transaxle)
5. Remove flywheel sub–assy (m/t transaxle ...
Inspection procedure
1 Check p squib circuit(airbag sensor assy center – instrument
panel passenger airbag assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connector between the airbag sensor
assy center and the instrument panel ...
Engine coolant
The coolant level is satisfactory if it is between the “F” and “L” lines on the
reservoir when the engine is cold.
1 Reservoir cap
2 “F” line
3 “L” line
If the level is on or below the “L” line, add coolant up to the “F” line.
■Coolant selection
Only use “To ...