Toyota Corolla (E120): Inspection procedure

Hint

: read freeze frame data using the hand–held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the air–fuel ratio was lean or rich, etc. At the time of the malfunction.

1 Check valve timing(check for loose and jumped tooth of timing chain)

Replace ecm

Replace ecm

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...

    Replacement
    1. Remove combination meter assembly 2. Disconnect brake master cylinder push rod clevis  remove the clip and push rod clevis pin and wave washer, and disconnect the push rod clevis from the brake pedal. 3. Remove brake pedal support sub–assy Remove the bolt from the bra ...

    Problem symptoms table
    Hint: use the table below to help determine the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, replace these parts. 1. Headlamp and tail lamp 2. Front fog lamp system 3. Turn signal and hazard warni ...