Toyota Corolla (E120): Inspection

1. Inspect defogger relay (marking: def)

  1. Remove the defogger relay from the instrument panel j/b.
  2.  inspect the defogger relay.

Standard:

If the result is not as specified, replace the relay

If the result is not as specified, replace the relay

    Share this page:

    Other materials:

    Circuit description
    The door key lock and unlock switch is built in the door lock motor. Wiring diagram Inspection procedure 1 Check door lock 2 Check wire harness (tvip ecu  door lock) Disconnect the tvip ecu and door lock connectors.  check the continuity between the terminals of the t ...

    Warning lights
    Warning lights inform the driver of malfunctions in the indicated vehicle’s systems. *1: Vehicles without a smart key system: These lights turn on when the engine switch is turned to the “ON” position to indicate that a system check is being performed. They will turn off after the engi ...

    Inspection procedure
    1 Check hazard warning signal switch assy Check the hazard warning switch continuity, as shown in the illustration and table. Standard: 2 Check turn signal flasher assy 3 Check wire harness (tvip ecu turn signal flasher) Disconnect the tvip ecu and turn signal flashe ...