Toyota Corolla (E170): Inside rear view mirror

The rear view mirror’s position can be adjusted to enable sufficient confirmation of the rear view.

Share this page:

Other materials:

Inspection procedure
1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...

Inside vehicle
General maintenance Performing these maintenance checks on the vehicle in the owner’s responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check the parts of the vehicle described below on a daily basis. In most cases, special tool are not requir ...

Engine (ignition) switch (vehicles without a smart key system)
Starting the engine 1. Check that the parking brake is set. 2. Check that the shift lever is in P. 3. Firmly depress the brake pedal. 4. Turn the engine switch to START to start the engine. ■If the engine does not start The engine immobilizer system may not have been deactivated. Contact your Toy ...