Toyota Corolla (E120): Ignition switch circuit

Share this page:

Other materials:

Overhaul
1. Remove generator pulley Sst 09820–63010 (09820–06010, 09820–06020) Hint: Hold sst 1 – a with a torque wrench, and tighten sst 1 – b clockwise to the specified torque. Torque: 39 nvm (398 Kgf·cm, 29 ft·lbf) Notice: check that sst is secured to the rotor shaft. ...

Front seat airbag assy rh
Disposal Hint: when scrapping vehicles equipped with an srs or disposing of the front seat airbag assy always first deploy the airbag in accordance with the procedure described below. If any abnormality occurs with the airbag deployment, contact the service dept. Of toyota motor sales ...

Hood
Release the lock from the inside of the vehicle to open the hood. 1 Pull the hood lock release lever. The hood will pop up slightly. 2 Pull up the auxiliary catch lever and lift the hood. 3 Hold the hood open by inserting the support rod into the slot. CAUTION ■Pre-driving check C ...