Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Readiness monitor drive pattern / Evap monitor (vacuum pressure monitor)
Toyota Corolla (E120): Evap monitor (vacuum pressure monitor)
Notice
: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor.
- Cold soak preconditions
The monitor will not run unless:
- mil is off.
- Fuel level is approximately 1/2 to 3/4.
- Altitude is 7800 feet (2400 m) or less.
- cold soak procedure
Let the vehicle cold soak for 8 hours or until the difference between iat and ect becomes less than 13°f (7 °C).
Hint
: examples:
- scenario 1
ect = 75°f (24 °C)
iat = 60°f (16 °C)
difference between ect and iat is 15°f (8 °C).The monitor will not run because difference between ect and iat is greater than 13°f (7 °C).
- Scenario 2
ect = 70°f (21 °C)
iat = 68°f (20 °C)
difference between ect and iat is 2°f (1 °C).The monitor will run because difference between ect and iat is less than 13°f (7 °C).
Other materials:
Diagnostic trouble code chart
Hint:
when the srs warning light remains lit up and the dtc is the normal
code, this means a voltage source
drops.
This malfunction is not stored in memory by the airbag sensor assy center
and if the power source
voltage returns to normal, the srs warning light will autom ...
Power steering
Preparation
Sst
Recomended tools
Equipment
Lubricant
Ssm
...
Overhaul
Hint:
overhaul the rh side by the same procedure as the lh side.
1. Remove front wheel
2. Drain brake fluid
Notice:
wash the brake fluid off immediately if it comes into contact with any painted
surface.
3. Remove front disc brake cylinder sub–assy
Remove the union bolt and gasket ...


