Toyota Corolla (E170): Engine

*: Drive belt tension measured with Borroughs drive belt tension gauge No.

*: Drive belt tension measured with Borroughs drive belt tension gauge No.

BT-33-73F (used belt), lbf

    Share this page:

    Other materials:

    Overhaul
    1. Remove console panel upper 2. Remove console box carpet 3. Remove parking brake hole cover sub–assy 4. Remove console box sub–assy rear 5. Disconnect floor shift cable transmission control shift Remove the cable end from the rod of the floor shift assembly. Using a s ...

    On–vehicle inspection
    1. Inspect turn signal flasher relay circuit Disconnect the connector from the turn signal flasher relay and inspect the connector on wire harness side as shown in the chart. Standard: Connect the connector to the turn signal flasher and inspect the wire harness side connector ...

    Light control switch circuit
    Wiring diagram Inspection procedure 1 Check headlamp dimmer switch assy (light control switch) 2 Check wire harness (tvip ecu  light control switch) Disconnect the tvip ecu and light control switch connectors.  check the continuity between the terminals of the tvip e ...