Toyota Corolla (E140): Body dimension drawings

Engine compartment

Body opening areas (side view: front)

Body opening areas (side view: front)

Body opening areas (side view: rear)

Body opening areas (side view: rear)

Sedan

Body opening areas (rear view)

Body opening areas (rear view)

Sedan

Under body

Under body

Under body

Under body

Front suspension crossmember

Front suspension crossmember

Front suspension crossmember

Front suspension crossmember

Reference value

    Share this page:

    Other materials:

    Circuit description
    The rear heated oxygen sensor is used to monitor oxygen concentration in the exhaust gas. For optimum catalytic converter operation, the air fuel mixture must be maintained near the ideal ”stoichiometric” ratio. The heated oxygen sensor output voltage changes suddenly in the vicinity of ...

    Replacement
    1. Remove instrument panel sub–assy lower 2. Remove clutch pedal spring 3. Remove clutch master cylinder push rod clevis w/hole pin Remove the clip and hole pin. 4. Remove clutch pedal support sub–assy W/ cruise control: disconnect the clutch switch assy connector. &nbs ...

    Check and replace ecu
    Notice: start an inspection of the connector from the backside of the connector on the wire harness side with the connector connected to the ecu. When no measurement condition is specified, perform the inspection with the engine stopped and also the ignition switch on. First check the ec ...