Toyota Corolla (E120): Cruise control actuator assy

Replacement

1. Remove cruise control actuator cover

  1. Disengage the 2 claws, then remove the cruise control actuator cover.

2. Separate accelerator control cable assy

  1. Loosen the double nut and separate the accelerator control cable assy.

3. Separate accelerator auto drive cable assy

  1. Remove the screw and separate the accelerator auto drive cable assy.

4. Remove cruise control actuator assy

  1. Remove the screw and separate the accelerator auto drive cable assy.
  2. Remove cruise control actuator assy

Clutch switch assy

Replacement

1. Remove clutch switch assy

  1.  disconnect the connector.
  2.  loosen the nut and remove the clutch switch assy.
    Share this page:

    Other materials:

    Safety information for children
    Observe the following precautions when children are in the vehicle. Use a child restraint system appropriate for the child, until the child becomes large enough to properly wear the vehicle’s seat belt. ● It is recommended that children sit in the rear seats to avoid accidental contact ...

    Inspection procedure
    Hint: when the throttle position is slightly opened (the accelerator pedal is slightly depressed) because a floor carpet is overlapped on the accelerator pedal, or if not fully releasing the accelerator pedal, etc., Dtc p505 will possibly be detected. Read freeze frame data using the ...

    Changing the passkey
    1 Select “Passkey” using . 2 Input a 4 to 8-digit passkey using . Input the number 1 digit at a time. 3 When the entire number to be registered as a passkey has been input, press again. If the passkey to be registered has 8 digits, pressing again is not necessary. ...