Toyota Corolla (E120): Components

Overhaul

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect transmission wire(s2) Disconnect the transmission wire connector from the transaxle.  measure the resistance according to the value(s) in the table below. Standard: 2 Check harness and connector(transmission wire – ecm) Connect the transmission connec ...

    Evap monitor (vacuum pressure monitor) (continued)
    Preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less.* Engine coolant temperature (ect) is between 40°f and 95°f (4.4 °C and 35 °C). Intake air temperature (iat) is between 40°f and 95 ...

    Inspection procedure
    Hint: read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the ...