Toyota Corolla (E120): Circuit description
The p/t squib (lh) circuit consists of the airbag sensor assy center and seat belt pretensioner (lh).
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b0137/71 is recorded when a ground short is detected in the p/t squib (lh) circuit.
Wiring diagram
Other materials:
Precaution
1. Handling precautions on srs airbag system
The vehicle is equipped with srs (supplemental restraint system) such as
the driver airbag and front
passenger airbag. Failure to carry out service operation in correct sequence
could cause the srs to
unexpectedly deploy during servicing, po ...
Removal & installation and disassembly & reassembly
1. Remove oxygen sensor
Remove a clip and tear off the floor mat.
disconnect a oxygen sensor connector.
Remove the oxygen sensor.
2. Remove tail pipe assy
Remove 2 bolts, 2 springs and tail pipe assy.
3. Remove floor panel brace front
Remove 2 nuts and the ...
Replacement
1. Disconnect battery negative terminal
2. Remove engine under cover rh
3. Remove starter assy
Disconnect the starter connector.
open the terminal cover.
remove the nut, then disconnect the starter wire.
remove the 2 bolts, then remove the starter.
4. Install starter a ...