Toyota Corolla (E120): Circuit description

The side squib (lh) circuit consists of the airbag sensor assy center and front seat airbag assy (lh).

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0115/47 is recorded when a short is detected in the side squib (lh) circuit.

Wiring diagram

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Driving assist systems
    To keep driving safety and performance, the following systems operate automatically in response to various driving situations. Be aware, however, that these systems are supplementary and should not be relied upon too heavily when operating the vehicle. Summary of the driving assist systems ■ ABS ( ...

    Inspection procedure
    1 Check front airbag sensor (lh) circuit (to b+)(airbag sensor assy center – airbag sensor front lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the airbag ...

    Diagnostic trouble code chart
    The inspection procedures are shown in the table below. This table allows efficient and accurate troubleshooting using the diagnostic trouble codes displayed in the diagnostic trouble code chart. Proceed with troubleshooting in accordance with the inspection procedures listed in the diagnost ...