Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Camshaft position ”a” –timing over

Toyota Corolla (E120): Camshaft position ”a” –timing over

Dtc p0011 camshaft position ”a” –timing over– advanced or system performance (bank 1)

Dtc p0012 camshaft position ”a” –timing over– retarded (bank 1)

Share this page:

Other materials:

On–vehicle inspection
1. Inspect pressure switch no.1. Magnetic clutch control: inspect pressure switch operation.  Set on the manifold gauge set.  Connect the positive (+) lead from the ohmmeter to terminal 4 and the negative (–) lead to terminal 1.  Check continuity between termin ...

Starting system
Inspection 1. Inspect starter assy Notice: these tests must be performed within 3 to 5 seconds to prevent burnout of the coil.  perform the pull–in test.  Remove the nut, then disconnect the lead wire from terminal c. Connect the battery to the starter repai ...

Problem symptoms table
Hint: use the table below to help determine the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, replace these parts. 1. Headlamp and tail lamp 2. Front fog lamp system 3. Turn signal and hazard warni ...