Toyota Corolla (E120): Camshaft
Other materials:
Oxygen sensor monitor (front and rear o2s system)
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 2 minutes or more.
Drive the vehicle at 25 mph ...
Inspection procedure
1 Reconfirm dtc
Check the dtc
2 Inspect skid control ecu connector securely connected
3 Inspect skid control ecu connector(ig1 terminal voltage)
In case of using hand–held tester:
check the voltage condition output from the ecu displayed on the
hand–held tester.
O ...
Inspection
1. Headlamp dimmer switch assy
Inspect light control switch continuity.
Measure the resistance according to the value(s) in
the table below.
Standard:
Inspect headlight dimmer switch continuity.
Measure the resistance according to the value(s) in
the tabl ...


