Toyota Corolla (E120) 2002–2008 Repair Manual / Brake / Brake master cylinder sub–assy

Toyota Corolla (E120): Brake master cylinder sub–assy

Share this page:

Other materials:

Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...

Circuit description
Hint: these dtcs indicate a malfunction related to the primary circuit. If dtc p0351 is displayed, check the no.1 Ignition coil with igniter circuit. If dtc p0352 is displayed, check the no.2 Ignition coil with igniter circuit. If dtc p0353 is displayed, check the no.3 Ignition coil ...

Back up lamp assy lh
Replacement 1. Remove back up lamp assy lh Remove the service hole cover.  remove the 2 nuts and disconnect the connector. Using a mouldingremover, remove the 2 clips and back up light assy lh. 2. Install back up lamp assy lh Set the 2 clips on the back up ligh ...