Toyota Corolla (E140) 2007–2013 Body Repair Manual / Paint coating / Body panel anti-rust agent (wax) application areas

Toyota Corolla (E140): Body panel anti-rust agent (wax) application areas

Apply rustop w to the doors and hood edges (tips of outer panel folded parts) and undersides, areas around hinges, etc.To prevent rust. Coat the undersides of the edges using a nozzle and air gun, and coat the areas around the hinges using a brush.

Hint:

  1.  if rustop is unnecessarily applied to an area, apply degreasing agent to a clean cloth and clean off the rustop immediately.

Silencer sheet installation areas

    Share this page:

    Other materials:

    Pre–check
    1. Pre–check Check that the cruise control actuator assy, acceleration wire, accelerator auto drive cable assy, and link assy are installed correctly and that the wire and link are securely connected. check that the operating movement of the acceleration pedal, cruise control actu ...

    Inspection procedure
    1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...

    Circuit description
    The crankshaft position sensor (ne signal) consists of a magnet, iron core and pickup coil. The ne signal plate (crankshaft position sensor plate) has 34 teeth and is installed on the crankshaft. The ne signal sensor generates 34 signals for each engine revolution. This sensor monitors a p ...