Toyota Corolla (E120): Replacement

1. Remove clutch start switch assy

  1.  disconnect the clutch start switch assy connector.
  2.  remove the nut and clutch start switch assy from the clutch pedal support.

2. Install clutch start switch assy

  1.  install the clutch start switch assy with the nut.

    Torque: 15.68 Nvm (160 Kgf·cm, 12 ft·lbf)

  2.  connect the clutch start switch assy connector.

3. Inspect clutch start switch assy

    Share this page:

    Other materials:

    Entire combination meter does not operate
    Wiring diagram Inspection procedere 1 Check fuse Check that continuity exists of dome fuse.  check that continuity exists of gauge fuse.  check that continuity exists of am1 fuse. 2 Inspect combination meter assy Check continuity.  Disconnect the ” ...

    If your vehicle has to be stopped in an emergency
    Only in an emergency, such as if it becomes impossible to stop the vehicle in the normal way, stop the vehicle using the following procedure: Stopping the vehicle 1. Steadily step on the brake pedal with both feet and firmly depress it. Do not pump the brake pedal repeatedly as this will increase t ...

    Replacement
    1. Work for preventing gasoline from spilling out 2. Remove front wheels 3. Remove engine under cover rh 4. Remove engine under cover lh 5. Drain coolant 6. Remove cylinder head cover no.2 Remove the 2 nuts, 2 clips and cylinder head cover. 7. Disconnect radiator hose inlet &nb ...