Toyota Corolla (E120): Rear suspension

Components

Rear wheel alignment

    Share this page:

    Other materials:

    Circuit description
    Monitor description The ecm commands gearshift by turning the shift solenoid valves ”on/off”. When there is an open or short circuit in any shift solenoid valve circuit, the ecm detects the problem and the mil comes on. Illuminating the mil, the ecm performs the fail–safe and turns ...

    Rear axle beam assy
    Replacement Hint: components:  1. Remove rear wheel  remove the rh and lh rear wheels. 2. Remove rear brake drum sub–assy 3. Separate skid control sensor wire Disconnect the skid control sensor connector.  remove the 2 bolts and separate the wire harness clamp ...

    Inspection procedure
    1 Check connector Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  check the connection of the combination meter connector and the airbag sensor assy center connectors. Ok: the connectors are connected. 2 Check combination ...