Toyota Corolla (E120): Proportioning valve assy

Share this page:

Other materials:

Replacement
Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. 1. Remove luggage compartment door cover 2. Remove rear spoiler  remove the 2 screws.  disconnect the wire harness connector.  put protective tape. &nb ...

Terminals of ecu
Oscilloscope wave (*1) Hint: terminal: od – gnd gauge set: 5 v / div, 50 ms / div condition: during cruise control driving o/d switch on. ...

Removal & installation and disassembly & reassembly
1. Remove oxygen sensor Remove a clip and tear off the floor mat.  disconnect a oxygen sensor connector. Remove the oxygen sensor. 2. Remove tail pipe assy Remove 2 bolts, 2 springs and tail pipe assy. 3. Remove floor panel brace front Remove 2 nuts and the ...