Toyota Corolla (E120): Manual transmission / transaxle

Service data

Torque specification

Torque specification

Clutch

    Share this page:

    Other materials:

    Inspection procedure
    1 Check hazard warning signal switch assy Check the hazard warning switch continuity, as shown in the illustration and table. Standard: 2 Check turn signal flasher assy 3 Check wire harness (tvip ecu turn signal flasher) Disconnect the tvip ecu and turn signal flashe ...

    Inspection procedure
    1 Inspect shift solenoid valve(s1) Remove the shift solenoid valve s1. measure the resistance according to the value(s) in the table below. Standard: Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the solenoid ...

    Hydraulic test
    1. Perform hydraulic test Measure the line pressure. Notice: Do the test at normal operation atf temperature 50 to 80 °c (122 to 176 °f). The line pressure test should always be carried out in pairs. One technician should observe the conditions of wheels or wheel stopper outsi ...