Toyota Corolla (E170): Manual connection

When auto connection has failed or “Bluetooth* Power” is turned off, you must connect the Bluetooth® device manually.

*: Bluetooth is a registered trademark of Bluetooth SIG, Inc.

1 Follow the steps in “Connecting a Bluetooth® device” from “STEP

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect transmission wire(s2) Disconnect the transmission wire connector from the transaxle.  measure the resistance according to the value(s) in the table below. Standard: 2 Check harness and connector(transmission wire – ecm) Connect the transmission connec ...

    On–vehicle inspection
    1. Inspect w/receiver condenser assy  if a fin of the w/receiver condenser assy is dirty, clean it with water and dry it with compressor air. Notice: do not damage the fin of the w/receiver condenser assy.  if a fin of the w/receiver condenser assy is bent, make it straig ...

    Replacement
    Hint: components:  1. Remove front wheel 2. Remove front axle hub lh nut  sst 09930–00010 3. Separate front stabilizer link assy lh 4. Separate speed sensor front lh (w/ abs) 5. Separate front disc brake caliper assy lh Remove the 2 bolts, separate the brake caliper assy ...