Toyota Corolla (E120): Instrument panel sub–assy lower

Share this page:

Other materials:

Inspection
1. Cooler thermistor no.1 Check resistance between terminals 1 and 2 of cooler thermistor no. 1 At each temperature, as shown in the chart. Resistance: If resistance value is not as specified, replace the sensor. 2. Cooler and accessory assy Inspect blower switch contin ...

Inspection procedure
Hint Advanced timing over (valve timing is out of specified range) P0011 Retarded timing over (valve timing is out of specified range) P0012 If dtc p0011 or p0012 is displayed, check the vvt system circuit. Read freeze frame data using the hand–held tester o ...

Overhaul
1. Remove repair service starter kit Remove the nut, then disconnect the lead wire from terminal c. Remove the 2 screws which are used to secure the repair service starter kit to the starter drive housing.  remove the repair service starter kit.  remove the return ...