Toyota Corolla (E210): Hood
Opening the hood
1. Pull the hood lock release lever.
The hood will pop up slightly.
2. Pull the auxiliary catch lever to the left and lift the hood.
3. Hold the hood open by inserting the support rod into the slot.
WARNING
■Pre-driving check
Check that the hood is fully closed and locked.
If the hood is not locked properly, it may open while the vehicle is in motion and cause an accident, which may result in death or serious injury.
■After installing the support rod into the slot
Make sure the rod supports the hood securely preventing it from falling down onto your head or body.
NOTICE
■When closing the hood
Be sure to return the support rod to its clip before closing the hood.
Closing the hood with the support rod not clipped could cause the hood to bend.
Other materials:
Inspection procedure
Hint:
if different dtcs related to different systems that have terminal e2
as the ground terminal are output
simultaneously, terminal e2 may be open.
Read freeze frame data using the hand-held tester or the obd ii scan
tool. Freeze frame data records
the engine conditions when a malf ...
Problem symptoms table
Hint:
proceed with troubleshooting of each circuit in the table below.
Symptom
Suspect area
When the ignition switch is in the on position, the srs warning
light sometimes comes on after approximately 6 seconds.
Srs warning light ci ...
Replacement
1. Remove battery
2. Remove battery carrier
Remove the 4 bolts and battery carrier.
3. Disconnect floor shift cable transmission control shift
Remove the nut from the control shaft lever.
disconnect the control cable from the control shaft lever.
remove the clip a ...