Toyota Corolla (E170): Glossary of tire terminology

*: Table 1 - Occupant loading and distribution for vehicle normal load for various

*: Table 1 - Occupant loading and distribution for vehicle normal load for various designated seating capacities

Customization

    Share this page:

    Other materials:

    Circuit description
    The actuator motor is operated by signals from the cruise control ecu assy. Acceleration and deceleration signals are transmitted by changes in the duty ratio (see below). Duty ratio: the duty ratio is the ratio of the period of continuity in one cycle. For example, if a is the period of co ...

    Fail–safe chart
    If any of the following codes is recorded, the ecm enters the fail–safe mode. Check for intermittent problems Hand–held tester only: by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is possible instead of the 2 trip detection logic, and the sensitivity to de ...

    Inspection procedure
    1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...