Toyota Corolla (E120): Front brake

Share this page:

Other materials:

Basic inspection
Resistance measuring condition of electronic parts  unless stated, all resistance is measured at an ambient temperature of 20 c (68 °F). As the resistance may be outside the specifications if measured at high temperatures immediately after the vehicle has been running, measu ...

Inspection procedure
1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and rele ...

Do-it-yourself service precautions
If you perform maintenance by yourself, be sure to follow the correct procedure as given in these sections. CAUTION The engine compartment contains many mechanisms and fluids that may move suddenly, become hot, or become electrically energized. To avoid death or serious injury, observe t ...