Toyota Corolla (E120) 2002–2008 Repair Manual / Automatic transmission / trans / Floor shift assy (atm)
Toyota Corolla (E120): Floor shift assy (atm)
Other materials:
Hydraulic test
1. Perform hydraulic test
Measure the line pressure.
Notice:
Do the test at normal operation atf temperature 50 to 80 °c (122 to
176 °f).
The line pressure test should always be carried out in pairs. One
technician should observe
the conditions of wheels or wheel stopper outsi ...
Checking and replacing fuses
If any of the electrical components
do not operate, a
fuse may have blown. If this
happens, check and replace
the fuses as necessary.
Checking and replacing
fuses
1. Turn the engine switch off.
2. Open the fuse box cover.
Engine compartment: type A
fuse box
Push the tabs in and lift the lid off.
E ...
Skid control sensor
Replacement
Hint:
replace the rh side by the same procedure as the lh side.
1. Remove rear wheel
2. Remove rear brake drum sub–assy
3. Disconnect skid control sensor wire
Disconnect the skid control sensor wire connector from
the skid control sensor.
4. Remove rear axle hub & ...