Toyota Corolla (E210): Essential information

Share this page:

Other materials:

Removal & installation and disassembly & reassembly
1. Remove bench type rear seat cushion assy 2. Remove rear floor service hole cover Remove the rear service hole cover. Disconnect the fuel pump and vapor pressure sensor connector. 3. Work for preventing gasoline from spilling out Start the engine.  after the engi ...

Circuit description
The side squib (lh) circuit consists of the airbag sensor assy center and front seat airbag assy (lh). It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b0115/47 is recorded when a short is detected in the side squib (lh) circuit. Wiring diagram ...

Inspection procedure
1 Check door lock 2 Check wire harness (tvip ecu door lock) Disconnect the tvip ecu and door lock connectors.  check the continuity between the terminals of the tvip ecu and door lock connectors, as shown in the illustration and table. Standard: 3 Check wire harness ...