Toyota Corolla (E170): Driving the vehicle

The following procedures should be observed to ensure safe driving:

Starting the engine

Share this page:

Other materials:

Source voltage drop
The srs is equipped with a voltage–increase circuit (dc–dc converter) in the airbag sensor assy center in case the source voltage drops. When the battery voltage drops, the voltage–increase circuit (dc–dc converter) functions to increase the voltage of the srs to normal voltage. ...

Lubrication system
On–vehicle inspection 1. Check engine oil level  after warming up the engine and then 5 minutes after the engine stops, oil level should be between the ”l” and ”f” marks on the oil level gage. If low, check for leakage and add oil up to the ”f” mark. Notice: do not ...

Inspection procedure
1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...