Toyota Corolla (E120): Cooling

Preparation

Recomended tools

Equipment

Equipment

Coolant

Coolant

Lubrication

    Share this page:

    Other materials:

    Inspection procedure
    1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

    Outside vehicle
    General maintenance Performing these maintenance checks on the vehicle in the owner’s responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check the parts of the vehicle described below on a daily basis. In most cases, special tool are not requir ...

    Inspection procedure
    1 Check low pitched horn assy Connect the positive (+) lead from the battery to the terminal and negative (–) lead to the horn body, and check that the horn blows. 2 Check relay (marking: horn) Remove the relay from the engine room j/b.  check the horn relay conti ...