Toyota Corolla (E120): Components

Replacement

    Share this page:

    Other materials:

    On–vehicle inspection
    1. Install lspv gauge (sst) and bleed air  remove the bleeder plugs from the front and rear brake cylinder.  install the lspv gauge (sst), and bleed the air. Sst 09709–29018 2. Raise master cylinder pressure and check rear wheel cylinder pressure Hint: when inspectin ...

    Problem symptoms table
    Proceed to the reference page shown in the table below for each malfunction symptom and troubleshoot each circuit. Hint: troubleshooting of the tvip system is based on the premise that the door lock control system and wireless door lock control system is operating normally. Accordingly, be ...

    Inspection procedure
    1 Check connector Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  check the connection of the combination meter connector and the airbag sensor assy center connectors. Ok: the connectors are connected. 2 Check combination ...