Toyota Corolla (E120): Components
Other materials:
Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal)
Turn the ignition switch to on.
measure voltage between terminals tc and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector betw ...
Circuit description
When driving uphill under cruise control, in order to reduce the number of
shifting due to on–off overdrive
operation and to provide smooth driving, when down shifting in the
electronically controlled transmission occurs,
a signal to prevent upshift until the end of the uphill slope is sent ...
Overhaul
Caution:
wear the gloves, because the cutting surface of the seat back frame and seat
adjuster may injure
your hand.
Hint:
tape the screwdriver tip before use when prying parts.
1. Disconnect battery negative terminal
Caution:
wait for 90 seconds after disconnecting the battery terminal a ...