Toyota Corolla (E120): Components

Replacement

    Share this page:

    Other materials:

    Oxygen sensor monitor (front and rear o2s system)
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

    Using the radio
    Radio operation Select “AM” or “FM” to begin listening to the radio. 1 Power 2 Volume 3 Station selectors 4 Adjust frequency or select an item 5 AM/FM mode button 6 Scan for receivable stations 7 Seek a frequency Setting station presets 1Search for a desired station by turning ...