Toyota Corolla (E120): Combination meter

Share this page:

Other materials:

Overhaul
1. Remove repair service starter kit Remove the nut, then disconnect the lead wire from terminal c. Remove the 2 screws which are used to secure the repair service starter kit to the starter drive housing.  remove the repair service starter kit.  remove the return ...

Oxygen sensor monitor (front and rear o2s system)
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

Safety Connect
*: If equipped Safety Connect is a subscription- based telematics service that uses Global Positioning System (GPS) data and embedded cellular technology to provide safety and security features to subscribers. Safety Connect is supported by Toyota's designated response center, which operates 24 hour ...