Toyota Corolla (E170): Bluetooth® device registration status

1 Display the “Bluetooth* Setup” screen.

*: Bluetooth is a registered trademark of Bluetooth SIG, Inc.

2 Select the device.

3 Select “Device Info”.

4 Following screen is displayed:

1 Device Name
2 Change connection method 3 Bluetooth® Address
4 Display your telephone number The number may not be displayed depending on the model of phone.

5 Compatibility profile of the device 6 Restore default settings

Changing connection method

    Share this page:

    Other materials:

    Oxygen / af sensor heater monitor
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

    Inspection procedure
    1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

    Center stop lamp assy
    Replacement 1. Remove package tray trim panel assy (w/o rear spoiler) 2. Remove center stop lamp assy (w/o rear spoiler) Remove the center stop light assy as shown in the illustlation. 3. Remove center stop lamp assy (w/ rear spoiler) Remove the 2 screws.  disconnect th ...