Toyota Corolla (E210): Before driving

Share this page:

Other materials:

Inspection procedure
1 Inspect shift solenoid valve(s2) Remove the shift solenoid valve s2.  measure the resistance according to the value(s) in the table below. Standard: Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the so ...

Overhaul
1. Remove roof headlining assy 2. Remove sliding roof glass sub–assy  using a torx wrench (t25), remove the 4 screws the sliding roof glass.  pull the glass upward to remove it. 3. Remove sliding roof weatherstrip 4. Remove sliding roof drive gear sub–assy Notice: ...

Terminals of ecu
1. Inspect integration relay Disconnect the connector and check the continuity of each terminal of the disconnected connector. Standard : If the result is not as specified, the vehicle’s side may malfunction. Reconnect the connector and check each terminal. Standard: If ...