Toyota Corolla (E120): Back window glass

Share this page:

Other materials:

Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

Replacement
1. Remove instrument panel sub–assy lower 2. Remove clutch pedal spring 3. Remove clutch master cylinder push rod clevis w/hole pin Remove the clip and hole pin. 4. Remove clutch pedal support sub–assy W/ cruise control: disconnect the clutch switch assy connector. &nbs ...

Engine oil
With the engine at operating temperature and turned off, check the oil level on the dipstick. ■ Checking the engine oil 1 Park the vehicle on level ground. After warming up the engine and turning it off, wait more than 5 minutes for the oil to drain back into the bottom of the engine. 2 ...