Toyota Corolla (E120): Evaporative emission control system

Dtc p0441 evaporative emission control system incorrect purge flow

Dtc p0446 evaporative emission control system vent control circuit

Share this page:

Other materials:

Inspection procedure
1 Check source voltage Measure the voltage of the battery. Ok: voltage: 10 – 14 v 2 Check air bag sensor assy center Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors from the airbag sensor assy ...

Replacement
1. Remove combination meter assembly 2. Disconnect brake master cylinder push rod clevis  remove the clip and push rod clevis pin and wave washer, and disconnect the push rod clevis from the brake pedal. 3. Remove brake pedal support sub–assy Remove the bolt from the bra ...

Terminals of ecu
1. Inspect integration relay Disconnect the connector and check the continuity of each terminal of the disconnected connector. Standard : If the result is not as specified, the vehicle’s side may malfunction. Reconnect the connector and check each terminal. Standard: If ...