Toyota Corolla (E120) 2002–2008 Repair Manual / Emission control
Toyota Corolla (E120): Emission control
- Emission control system
- Engine assembly
- Fan and generator v belt
- Valve clearance
- Partial engine assy
- Chain sub–assy
- Camshaft
- Cylinder head gasket
- Timing gear cover oil seal
- Engine rear oil seal
- Cylinder head assy
- Cylinder block assy
Other materials:
Out side moulding
Replacement
Hint:
use the same procedures for the rh side and lh side.
1. Remove outside moulding
Put protective tape around the moulding.
insert a piano wire between the vehicle body and moulding.
tie objects that can serve as handles (for example, wooden
blocks) to all ...
Inspection procedure
1 Check p squib circuit(airbag sensor assy center – instrument
panel passenger airbag assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connector between the airbag sensor
assy center and the instrument panel ...
Installing the spare tire
1 Remove any dirt or foreign matter from the wheel contact surface.
If foreign matter is on the wheel contact surface, the wheel nuts may loosen
while the vehicle is in motion, causing the tire to come off.
2 Install the tire and loosely tighten each wheel nut by hand by approximately
the sa ...